How to Install the Rear Brake Pads of the Changfeng Leopard CS10

Here are the steps for installing the rear brake pads of the Changfeng Leopard CS10:

1. Disengage the brake button, remove the tire, and remove the brake caliper. Then, remove the rear brake caliper and use the E40 tool to拆下 the electric brake motor (with two screws). Next, rotate the electric brake caliper axis in a counterclockwise direction until it is tight.

2. Use a brake tool to compress the brake caliper (you can also gently push it with a starter). Install the new brake pads, and then install the electric brake motor normally.

3. After installing the brake pads, press the brake button several times. If necessary, test the brake on the road. Finally, reset the system.

Note: Do not include any information about following, liking, commenting, or sharing this post.